geo said:Bunny Boots?
Years and years ago (1970/1971) the Canadian Army had these tremendous blocks of rubber that we fondly refered to as "Mickey Mouse" boots... They looked very much like the "Bunny" boots - but there were no inflation valves on the side.
Xfire said:are you talking about the overboots?
tomahawk6 said:The air valves had to be opened up while flying. Of course the wags in the unit would tell newbies that the valves were to be uased for blowing ait into the boots to "make the boots warmer". ;D
The NFLD Grinch said:You mean these geo?
Knecht Ruprecht said:I'm a tad lost... why do they have an air valve in the first place?
geo said:They certainly look familiar... haven't come close to any of em for +/- 30 yrs
My feet and ankles ache at the very thought of wearing em..... no flex
geo said:The Cdn Mickey Mouse boots had no valve... never had the pleasure.
One explanation was so the Yanks could inflate the boots with helium because they all wanted to be a little "light in the loafers".Knecht Ruprecht said:I'm a tad lost... why do they have an air valve in the first place?
By 1971 exploratory engineer development had commenced on a LINCLOE micro-cellular urethane coated boot with outsoles and unit-molded upper portions. Each boot weighed only 23 ounces. The pull-on “semi-jackboot” style boots were easy to put on and take off, and the “Vibram” design gave good traction. The close-fitting ankle design provided adequate ankle support.
The white rubber cold-dry insulated boots with release valve were designed to protect the feet in temperatures as low as minus 60 degrees Fahrenheit. The boots were made of white latex and calendered rubber compound with a seamless inner and outer carcass and sealed insulation. They were worn over one pair of cushion-sole socks. The outside air-release valve provided parachutists with a means of equalizing external and internal air pressures when undergoing altitude changes. The valve was closed at all other times to prevent moisture from reaching the boot’s insulation and rendering it unserviceable.
The NFLD Grinch said:You mean theseUS "Bunny Boots" vs theseCF Mukluks
Canadian Military extreme cold weather boots :Rated to -60 C.
US Bunny Boots : Rated for temperates below -20 degrees F( -28.8888889 degree Celsius). Some white bunny boots apparently are rated to protect an inactive wearer to -40 degrees F (-40 degree Celsius), and an active wearer to -60 degrees F ( -51.1111111 degree Celsius). (U.S. Army Pub. "Cold Weather Injury Prevention" 2-8165)
So draw your conclusion from that.
TheHead said:They may be rated to -60 but you're feet have the propensity too start freezing at -20 in those pieces of garbage. I'm very pleased with the C Coy 1PPCLI OCs call too allow troops to wear non issued extreme weather boots when we went into the arctic. I had no problems at all ONCE with my feet for the twoish weeks I was up there. Back in 2002? Different story, I wore the crap they issued me and recieved frost bite on my feet multiple times.
Old Sweat said:I was issued Mickey Mouse boots in Petawawa; they were okay in a cold, wet climate but my feet sweated in them.
Mukluks were great in the Army of the West's cold, dry conditions.
What sucked was getting neither. We used to put on three pairs of wool socks under our old cloth overshoes and "clog" a lot to keep our feet just above numb circa 1958. Don't even ask about the rest of our winter gear, which we didn't have.